Polaris Quattro User Manual

English
15
Problem Solution
Cleaner is sluggish, running with less
power than normal or not
moving.
1. Check the wheel RPM. Target wheel speed is
28-32 RPM. If wheel speed is not in target range,
refer to Section 7 Adjust Wheel Speed.
2. Check for debris in the filter canister and clean, if
necessary.
3. Check the filter screen and the in-line filter and
clean, if necessary.
4. Clean the skimmer basket, pump basket, and pool
filter.
5. Check all of the hoses, connections, and swivels for
leaks that could cause loss of water pressure.
Cleaner does not climb walls.
1. Check the wheel RPM. Target wheel speed is
28-32 RPM. If wheel speed is not in target range,
refer to Section 7 Adjust Wheel Speed.
2. Ensure the hose is floating and the hose floats
are positioned properly. Position the first float (k)
up against the feed hose connector (j) and then
space hose floats 1-3 ft (30-90 cm) apart.
3. Check for debris in the filter canister and clean, if
necessary.
4. Adjust the thrust jet. Refer to Section 8 Fine
Tuning.
5. For smooth surface pools (tile, fiberglass, etc.),
replace both rear tires with PosiTrax
®
tires for
more traction (available from a Polaris
®
dealer).
Smooth Surface Pools (tile, fiberglass, etc.)
Problem Solution
Not enough traction on smooth
surface pools (tile,
fiberglass, etc.).
Replace both rear tires with PosiTrax tires for more
traction (available from a Polaris dealer).

Polaris Quattro Specifications

General

Type	Robotic
Pool Type	In-ground
Cleaning Coverage	Floor, Walls, and Waterline
Drive Mechanism	4-Wheel Drive
Warranty	2 years
Cable Length	60 ft
Hose Length	Not applicable (robotic)
Debris Intake	Large capacity