FINAL DRIVE
7.57
T ighten Jam Nuts
NOTE: Threads and Jam
Nuts Centered on Bracket
Bracket
Ill. 4
6. If the adjustment of the linkage on the rear
differential (Steps 1--5) does not work. Repeat
these steps on the linkage located under the front
hood. This linkage is closely attached to the rear
differential lever .
Linkage
Ill. 5
Rear Differential Linkage (Front)
DIFFERENTIAL LOCK LEVER
REMOVAL/INSTALLA
TION
(2X4 &
4X4)
1. Disconnect linkage cable from lock differential.
2. Remove the cotter key, washers and bushings that
attach lock differential to the cable and frame.
3. Pull off the shifter knob.
4. Lift lock differential out of mounting bracket and
away from frame.
5. Repeat the steps above in reverse order for the
differential lock lever installation.
Differential Lock Location
Differential
Lock
Cotter Key
Bushing
Spring
Grommet
Lock
Linkage Cable
W ashers
Bearing
Differential
Knob
Differential Lock Breakdown
To Next Page
Loading...
Need help?
General
