103
MAINTENANCE
Suspension Settings
Front/Rear Spring Preload
Walker Evans Shock Preload Adjustment
Follow these guidelines if you make adjustments to this suspension.
• Always return the suspension to the factory setting after the load is removed
from the vehicle. The increased suspension height will negatively impact vehi-
cle stability when operating without a load.
• Always apply the same adjustment setting to all four wheels.
• Do not increase the spring preload by more than one inch (25.4 mm) over the
factory setting.
1. Use the shock/clutch tool from the
tool kit to aid in making suspension
adjustments.
2. Elevate the vehicle to allow the sus-
pension to fully extend.
3. Turn the adjusting ring to the left (1)
to increase preload for a stiffer ride.
Turn the adjusting ring to the right (2)
to decrease preload for a softer ride.
WARNING! Uneven adjustment may cause
poor handling of the vehicle, which could result
in an accident. Always adjust both the left and
right spring preloads equally or have your
POLARIS dealer perform the adjustments.
To Next Page
Loading...
Need help?
General
