4. Include the weight of a rider
on the seat while performing
this step. Observe the
headlight aim. As a starting
point, the most intense part
of the headlight beam should
be 2 inches (5 cm)
w
below
the mark on the wall. Adjust
to operator preference.
5. Tighten or loosen the two (2)
headlight screws
r
to adjust
the beam upward or
downward or to the left or
right.
VEHICLE IMMERSION
NOTICE
If your vehicle becomes immersed, major engine damage can result if the
machine is not thoroughly inspected. Take the vehicle in for service before
starting the engine. Your POLARIS dealer can provide this service.
If it’s impossible to take your vehicle to a dealer before starting it, follow the
steps outlined below.
1. Move the vehicle to dry land.
2. Check the air box. See the Air Filter section for details. If water is present, dry
the air box and replace the filter with a new filter.
3. Remove the fuse/relay center cover. See the Fuse/Relay Center section for
details. Allow any moisture to dry, then reinstall the cover.
4. Dry the spark plug wells with a clean cloth, then remove the spark plugs.
5. Turn the engine over several times to expel any water from the engine
cylinders.
6. Dry the spark plugs and reinstall them, or install new plugs.
7. Attempt to start the engine. If necessary, repeat the drying procedure.
8. Take the vehicle in for service as soon as possible, whether you succeed in
starting it or not. Your POLARIS dealer can provide the required service.
9. If water has been ingested into the PVT follow the steps in the POLARIS
Variable Transmission (PVT) System section for drying procedures.
130
MAINTENANCE
To Next Page
Loading...
Need help?
General
