BATTERY INSTALLATION
NOTICE
Using a new battery that has not been fully charged can damage the battery
and result in a shorter life. It can also hinder vehicle performance. Follow the
instructions in the Battery Charging section before installing the battery.
1. Ensure the key switch is set to OFF position before installing the battery.
2. Remove the driver’s seat. See page 38.
3. Place the battery in the battery holder.
4.
Place the battery hold-down strap
q
across the battery.
5. Install the two screws
w
securing the battery hold-down strap. Torque
fasteners to specification.
TORQUE
Battery Mount Bracket Fasteners:
53 in-lbs (6 Nm)
6. Coat the terminals with dielectric grease or petroleum jelly.
7. Connect and tighten the POSITIVE (+) red cable
e
.
8. Connect and tighten the NEGATIVE (-) black cable
r
.
TORQUE
Battery Terminal Fasteners:
30 in-lbs (7 Nm)
9. Verify that cables are properly routed.
10. Reinstall the seat.
136
MAINTENANCE
To Next Page
Loading...
Need help?
General
