MODELS EQUIPPED WITH TWO BATTERIES
On models equipped with two batteries, do the following:
1. Ensure the key switch is set to OFF position before installing the battery.
2. Remove the driver’s seat. See page 38.
3. Place the both of the batteries in the battery holder.
4. Place the battery hold-down strap
q
across the battery.
5. Install the four screws
w
securing the two battery hold-down straps. Torque
fasteners to specification.
TORQUE
Battery Mount Bracket Fasteners:
53 in-lbs (6 Nm)
6. Coat the terminals with dielectric grease or petroleum jelly.
137
MAINTENANCE
To Next Page
Loading...
