OIL AND FILTER CHANGE
WARNING
Spilled oil left on engine components or in the engine area may pose a fire
hazard. Use shop rags to clean any spilled oil. If needed, use a non-flammable
solvent on the rag to aid the cleaning process. Do not use any device such as
pressurized water or air as this may disperse the oil onto engine components
and could pose a fire hazard.
CAUTION
Engine oil is hot after use and can cause burns to skin.
Always change the oil and filter at the intervals outlined in the Periodic
Maintenance Interval Chart.
1. Position the vehicle on a level surface. Place the transmission in PARK.
2. Allow engine to cool down before draining oil.
3.
Place a drain pan under the engine crankcase and remove the drain plug
q
using a 6 mm Allen wrench..
4. Access the oil filter through the driver’s side rear wheel well.
NOTICE
Wait two (2) minutes to allow oil to drain back to the sump.
93
MAINTENANCE
To Next Page
Loading...
Need help?
General
