DEMAND DRIVE FLUID CHECK
The fill plug is located on the bottom right side of the demand drive unit. Maintain
recommended fluid volume (250 ml). Do not overfill.
1. Position the vehicle on a level surface.
2. Remove the fill plug. Check the fluid level.
3. Add the recommended fluid to reach 250 ml capacity.
4. Reinstall the fill plug. Torque to specification.
DEMAND DRIVE FLUID CHANGE
The demand drive drain plug is located on the bottom of the gearcase.
1. Remove the fill plug.
2. Place a drain pan under the drain plug.
3. Remove the drain plug. Allow the fluid to drain completely.
4. Clean the drain plug.
5. Reinstall the drain plug. Torque to specification.
6. Add the recommended fluid (250 ml). Do not overfill.
7. Reinstall the fill plug. Torque to specification.
8. Check for leaks. Discard used fluid properly.
149
MAINTENANCE
To Next Page
Loading...
