BATTERY MAINTENANCE
See page 179 for storage and charging procedures.
STORAGE AREA / COVERS
Be sure the storage area is well ventilated. Cover the vehicle with a genuine
POLARIS cover. Do not use plastic or coated materials. They do not allow
enough ventilation to prevent condensation, and may promote corrosion and
oxidation.
REMOVAL FROM STORAGE
1. Charge the battery if necessary.
2. Make sure the spark plug is tight. Reinstall the fuse box cover if it was
removed for storage.
3. Fill the fuel tank with fuel.
4. Check all the points listed in the Daily Pre-Ride Inspection sectionb.
Tightness of the bolts, nuts and other fasteners should be checked by an
authorized POLARIS dealer or other qualified service facility.
5. Lubricate at the intervals outlined in the Periodic Maintenance Chart
beginning on page 114.
WARNING
Engine exhaust contains poisonous carbon monoxide and can cause loss of
consciousness or death. Never run an engine in an enclosed area.
TRANSPORTING THE VEHICLE
NOTE
For functional descriptions detailing how to operate the DYNAMIX suspension
system on certain vehicle models, consult the Polaris RideCommand manual.
Follow these procedures when transporting the vehicle.
NOTICE
After a ride, allow the engine to idle for 30 seconds before stopping the engine.
This will allow the turbo system to cool down.
186
MAINTENANCE
To Next Page
Loading...
Need help?
General
