HEADLIGHT SWITCH
The ignition switch key must be in the ON/RUN
position to operate the headlights. Press the top of the
switch to place the headlights on high beam. Move the
switch to the center position to place the headlights on
low beam. Press the bottom of the switch to turn off the
headlights. If the headlight switch is ON when the
ignition switch is turned off, the lights will remain on for
approximately 30 seconds.
ALL WHEEL DRIVE (AWD) SWITCH
The AWD switch has two positions:
• All Wheel Drive (AWD)
• Two Wheel Drive (2WD)
Press the top of the rocker switch to engage All Wheel
Drive. Press the bottom of the switch to operate in two
wheel drive. See the All Wheel Drive (AWD) System
section for AWD operating instructions.
AUXILIARY OUTLETS
The vehicle is equipped with one or more 12-volt
accessory outlets. One outlet is on the dash, a second
outlet (if equipped) is in the rear passenger area. Use
the outlets to power an auxiliary light or other optional
accessories. For service, the dash outlet connection is
under the dash. The rear outlet connection is under
the rear passenger seats.
33
FEATURES AND CONTROLS
To Next Page
Loading...
Need help?
General
