ITEM INSPECTION PROCEDURE
SEE
PAGE
Turn Signals Verify that the left and right turn signals flash at the front and
rear of the vehicle, and that the corresponding indicator lamp
flashes in the gauge.
-
Emergency
Flashers
Press the top of the hazard switch to turn the flashers on.
Verify that all four turn signals flash, as well as the lamps in the
gauge. Press the bottom of the switch to turn the flashers off.
Verify that all signals and indicator lamps stop flashing.
page
25
Horn Press the horn button. Verify that the horn sounds loudly.
-
Low Oil
Pressure
Indicator
Start the engine and verify that the low oil pressure lamp does
not illuminate.
page
31
Steering Check power steering for smooth operation.
page
67
General
Engine Oil
Level
Check the oil level.
page
101
Fuel Level View the fuel gauge to check the fuel level.
page
67
Coolant Level Check the surge tank coolant level.
page
110
Tires Inspect tire condition, pressure and tread depth.
page
122
Wheels Inspect for loose, damaged or missing wheel nuts.
page
123
Brake Fluid
Level
Check the master cylinder brake fluid level.
page
120
Park Brake Verify that the vehicle does not roll when the park brake is set.
page
50
Brake System Inspect brake system hoses, connections and brake pads.
Check brake pedal for excessive travel or a spongy feel.
page
121
Throttle Pedal Check throttle pedal travel, ensure smooth operation and full
return.
page
48
Clutch
System
Check fluid level and pedal travel.
page
116
Front
Suspension
Check for suspension wear or damage.
page
67
Rear
Suspension
Check for suspension wear or damage.
page
68
Drive Belt Check for wear or damage.
page
68,
page
113
Fasteners Inspect entire vehicle for loose, damaged or missing fasteners.
page
68
66
PRE-RIDE INSPECTIONS
To Next Page
Loading...
Need help?
General
