When the above setting is done, hold down the shutter button to record
continuous pictures.
NOTE:
• The ash does not re during the continuous shutter mode.
• You can not use the self timer in combination with the continuous shutter
mode.
• Continuous shutter recording is disabled while the
battery indicator is on the
monitor screen or the camera is off. The camera automatically switches to the
single mode.
• Using the Viewnder
Note the following points whenever you use the viewfinder to take
pictures.
The frame that is visible inside the viewfinder indicates the picture taken
at a distance of about three metres. When the subject is closer or further
away than three metres, the picture taken will be different from what you
see inside the viewfinder frame.
• When your subject is within 8 to 12 inches, use the macro mode to take
picture. Selecting the macro mode automatically turns on the monitor
screen, slide the monitor switch to
shows the
camera status on the monitor screen.
• Only the flash mode can be changed while the mode selector is set to
. Each time the flash button is pressed, the monitor will come on and
display the current flash settings.