14
Turning the Sound Bar on & off
You can turn the Sound Bar on by pressing
either the button on the Sound Bar or by
pressing the on the remote control.
Test mode: Press and hold the button
then power up the sound bar to select the test
mode, this mode is without DRC and the sound
setting is FLAT. It is not a mode that consumers
use.
Plugging the Sound Bar in
Slot the plug on the end of the power cable into
a wall socket and turn the power on if required.
Note: Ensure the power supply voltage
corresponds to the voltage stated on the back
or underside of the Sound Bar.
Before plugging the Sound Bar in, ensure that
all other connections have been completed.
Attaching the power cable
Slot the end of the power cable into the power
socket on the back of the Sound Bar.
To Next Page
Loading...