- DE and DER accumulation history;
- the preset DER and DE thresholds.
When using the instrument in a temperature range from -40°С up to –20 С the device
provides performance of the dosimetric functions without displaying the result of
measurement on LCD. When the instrument is returned to a temperature higher than –20 °С
LCD operates in a normal way.
The instrument performs continuous DER and DE measurement, DE accumulation
time counting in all modes, excluding an active mode of data transmission to PC (on/Ir).
Standard configuration of the instrument as includes the following parameters and
functions:
DER Indication Mode - On
Figure 1.2, Item 2 - DER values output.
Figure 1.2, Item 3 - output of the coefficient of variation values – Off.
Figure 1.2, Item 4 - output of DER values averaging – Off.
Thresholds setting enable: - Off Audible alarm:
Off.
DE Indication Mode - On
Figure 1.2, Item 2 - DE values output.
Figure 1.2, Item 3 - Output of DE accumulation time values in thousands
hours (symbol h is indicated at DE accumulation timeless than a thousand hours).
Figure 1.2, Item 4 - Output of DE accumulation time values in hours -
On
Figure 1.2, Item 4 - Output of values of time remaining for staying at the
working place - Off.
Thresholds setting enable - On DE reset – On.
Audible alarm – On.
Number Indication Mode - On
Figure 1.2, Item 2 - Dosimeter’s number.
Figure 1.2, Item 3 - Month of the dosimeter’s production.
Figure 1.2, Item 4 - Year of the dosimeter’s production.
Audible alarm - On.
Search mode - On.
Audible alarm indication mode - On.
Vibration alarm indication mode - On.
2.4.2 Selection of an indicated parameter
DER, DE, instrument’s number and data transmission to PC modes are switched on by a
successive pressing of the MODE button (Figure 2.1, Item 6).
The dosimeter allows for switching all the above-mentioned indication modes on and off.
Change of the configuration is performed in data transmission to PC mode.
17
To Next Page
Loading...
Need help?
General
