75
Emergency Alarm
Under standby mode, press + CALL, to activate this function, until you press
PTT, it will exit.
Channel Name storage and delete
Channel Storage.
Under VFO mode, input desired frequency by keypad directly, press then press
, the digits blinks at the right top of LCD, press number to input desired chan-
nel directly or press or , to choose desired one, then press for storage.
Note: after you input desired channel number, if it blinks, it means that this
channel is already occupied, you can choose another one.
E.g.: to store the frequency: 432.325 MHz to the channel 05, the step are as follows.
1. Under VFO mode, input 4-3-2-3-2-5.
2. Press + , press or , the step dial to choose number 5.
3. Press toconrm.
Channel delete
1. Under MR o CH mode, press [0] and switch on the transceiver at the same
time (the display will show “CH DEL?” with a channel number);
2. press or keys to select the channel you want to delete;
3. conrmbypressing key.
4. After delete, it will skip into next channel, if you want to delete it, repeat
above operation.
To Next Page
Loading...
