How to fix a POLMAR PMR446 that won't turn on?
If your POLMAR Transceiver shows no reaction when you try to power it on, the battery pack may be exhausted. Please change to a new battery or recharge the existing one. Alternatively, the battery pack may not be installed correctly; try reinstalling it.
What to do if my POLMAR Transceiver can't communicate with my group?
If you can't communicate with other members in your group using the POLMAR Transceiver, ensure that the frequency and CTCSS/DCS settings match those used by other members. Also, verify that you are within the communication range of the other group transceivers.
How to stop hearing other people on my POLMAR PMR446 Transceiver?
If you are hearing sounds from individuals outside your group on your POLMAR Transceiver channels, try changing the frequency. Additionally, change your CTCSS/DCS number, ensuring that all transceivers within your group also update to the new signal sound.
Why is the talking distance so short on my POLMAR Transceiver?
If the talking distance of your POLMAR Transceiver is shorter than expected, the squelch lever might be set too high. Please reduce the lever to improve the talking distance.
Why does my POLMAR PMR446 battery die so fast after charging?
If the battery of your POLMAR Transceiver drains quickly after being recharged, it could be that the battery's lifespan is over. Please replace it with a new battery. Also, ensure the battery has been completely charged.
What to do if my POLMAR PMR446 Transceiver voice is low or broken?
If people are reporting that your voice is low or broken when using the POLMAR Transceiver, check whether the microphone hole is blocked.
What to do if my POLMAR PMR446 has water damage?
If water gets into your POLMAR Transceiver, immediately remove the battery and drain out the water. Then, place the device in a ventilated area to dry. Make sure to send it to a maintenance station as soon as possible.
Lists included accessories like belt clip, battery pack, charger, adaptor, and user manual.
Explains how to set the RX CODE for station quietness when no set call is received.
Details the procedure for selecting the TX CODE for transmission, including CTCSS/DCS codes.
Instructions on how to turn the transceiver on and off using the power switch.
Explains how to adjust the audio volume up or down using the dedicated knob.
Details the correct procedure for transmitting a voice message using the PTT button.
Describes how to navigate and select the desired operating channel from standby mode.
How to switch between frequency and channel modes using the MENU button.
Instructions on how to initiate and exit the scanning mode to find active channels.
Explains how to lock and unlock the keypad to prevent accidental button presses.
Explains the meaning of different colored indicator lights during transmission, reception, and PC communication.
How to activate the keypad backlight and its duration.
How to use the monitor function to hear weak signals and bypass the squelch.
Instructions for accessing and using the built-in FM radio feature.
Describes the low voltage detection and alert system, including visual and audio warnings.
General| Frequency Range | 446.00625 - 446.09375 MHz |
|---|---|
| Channels | 8 |
| Power Output | 0.5W |
| Modulation | FM |
| Channel Spacing | 12.5 kHz |
| Battery Type | AAA |
To Next Page
