What to do if my POLMAR Transceiver has no power?
If your POLMAR Transceiver has no power, it could be due to a couple of reasons. First, the battery pack might be exhausted, so try replacing it with a new one or recharging the current battery. Alternatively, the battery pack may not be installed correctly. In this case, please try reinstalling it.
What to do if POLMAR MINI Transceiver has no or low voice when transmitting?
If you experience no or low voice when transmitting with your POLMAR Transceiver, first confirm that the volume is set to the highest level. If the volume is already at its maximum, then check if the microphone is damaged.
Why am I hearing other voices on my POLMAR MINI that aren't from group members?
If you're hearing voices that aren't from your group members on your POLMAR Transceiver, ensure that the frequency and CTCSS/DCS settings you are using are the same as those used by other members in your group. Also, the distance between you and other group members may be too far. Finally, make sure you are within the coverage range of other group transceivers.
Why does the POLMAR Transceiver battery drain quickly after being recharged?
If the battery of your POLMAR Transceiver drains quickly after being recharged, it may be because the battery's lifespan is over. Please replace it with a new battery.
Essential safety instructions for operation, servicing, and storage.
Warnings related to transceiver operation, temperature, and vehicle use.
Setting the Receive Code for quiet operation when no call is received.
Setting the Transmit Code for communication.
General| Brand | POLMAR |
|---|---|
| Model | MINI |
| Category | Transceiver |
| Language | English |
To Next Page
