POLMAR MINI - Automatic Power Off (APO)

38
menu 07. And SAVE displays.
Press [MODE] key again to enter the menu.
Clockwise or counterclockwise rotate [DIAL] knob to se-
lect: ON / OFF.
Press [MODE] key again to conrm after selected. Or
press [PTT] key to save the new settings and exit to nor-
mal operating mode.
(ON is to activate the power-saving mode: LCD shows “ “
power-saving icon and the transceiver will enter power-sa-
ving mode without signal receiving in 10 seconds at standby
state. OFF is to turn off power-saving feature.)
7. KTONE – Keypad tone setting ON / OFF
If the keypad tone causes inconvenience (especially operating
in the quiet room), it can cancel easily as following steps:
1) Press [MODE] key and then tune [DIAL] knob to enter
menu 08. And KTONE displays.
2) Press [MODE] key again to enter the menu.
3) Clockwise or counterclockwise rotate [DIAL] knob to
select: ON / OFF.
4) Press [MODE] key again to conrm after selected. Or
press [PTT] key to save the new settings and exit to nor-
mal operating mode.
(ON is for activating the keypad tone, and LCD displays
icon . OFF is to turn off keypad tone).
8. APO Automatically Power Off setting
Automatically Power OFF (APO) function refers to the tran-
sceiver turns off automatically without any operation when
there is no signal received in 30 minutes, which helps extend
the battery life. Following is steps to start the APO function:
Press [MODE] key and then tune [DIAL] knob to enter
menu 09. And APO displays.
Press [MODE] key again to enter the menu.
Clockwise or counterclockwise rotate [DIAL] knob to se-
lect: ON / OFF.
Press [MODE] key again to conrm after selected. Or
2.
3.
4.
1.
2.
3.
4.
1.
2.
3.
4.