Poly Edge E220 Installation Guide

• Select Login As Admin.
• Enter the Admin password.(default = 456, Enter
in a new admin password at the prompt and
remember what you set it to)
• Click Submit.
• Select Settings.
• Select Provisioning Server.
• Under Provisioning Server set the following values
• Server Address:
http://dms.digitalbusiness.telstra.com/dms/
bootstrap
• Server User:
<The supplied DMS user Credentials>
• Server Password:
<The supplied DMS Password Credentials>
• Expand the DHCP Menu
• Boot Server: Static
• Click Save
• The handset should reboot (this will take a minute
or two), if not Select Utilities, then select
Reboot Phone
Group level – NAPTR mode (Handset can be used on any network)
Tag Name Tag Value(s)
%TIPT_STATE%
(Based on the state)
vic-naptr
wa-naptr
tas-naptr
sa-naptr
qld-naptr
nt-naptr
nsw-naptr
 act-naptr
%IFOLDER%
1
%FIRMWARE_EDGE_E%
8.0.2
%SCA_FORWARD%
0
%TIPT_CODEC%
g722
Group level – TLS mode (Handset can be used on TBB /3rd Party)
Tag Name Tag Value(s)
%TIPT_STATE%
vic-tls
wa-tls
Tas-tls
sa-tls
qld-tls
nt-tls
nsw-tls
act-tls
%IFOLDER%
 1
%FIRMWARE_EDGE_E%
8.0.2
%SCA_FORWARD%
0
%TIPT_CODEC%
g722
Group level – UDP mode (Handset can be used on any network)
Tag Name Tag Value(s)
%TIPT_STATE%
(Based on the state)
vic-udp
wa-udp
tas-udp
sa-udp
qld-udp
nt-udp
nsw-udp
act-udp
%IFOLDER%
 1
%FIRMWARE_EDGE_E%
8.0.2
%SCA_FORWARD%
0
%TIPT_CODEC%
g722
Group level – TCP mode (Handset can be used on any network)
Tag Name Tag Value(s)
%TIPT_STATE%
vic-tcp
wa-tcp
tas-tcp
sa-tcp
qld-tcp
nt-tcp
nsw-tcp
act-tcp
%IFOLDER%
 1
%FIRMWARE_EDGE_E%
8.0.2
%SCA_FORWARD%
0
%TIPT_CODEC%
g722
TIPT – Polycom Edge series E220, E350 & E450 Installation Guide - 2023
3
Group Tags for TIPT Administration Portal
Note: If provisioned via UCSS, tags are set up automatically at the group level for the devices and if needed,
can be changed based on the customer requirements.

Poly Edge E220 Specifications

General

Brand	Poly
Model	Edge E220
Category	IP Phone
Language	English