Polycom SoundPoint Pro SE-225 - Restoring Flash Timing Default; Restoring System Factory Default Settings; Information Retention During a Power Loss; Troubleshooting

SoundPoint Pro Professional Conference Phone Troubleshooting
3 –1
SOUNDPOINT
®
PRO TROUBLESHOOTING
Chapter 3
Restoring Default Flash Timing
Enter the System Settings Directory then scroll ▼ until you see EDITFLASH TIME?
Press SELECT. Scroll ▲ until you see RESTORE DEFAULT FLASH TIME? Press
SELECT.
Restoring System Factory Default Settings
All factory system settings can be restored at the same time. Make sure you wish to
restore ALLfactory system settings before proceeding with this feature.
Enter the System Settings Directory then scroll ▼ until you see RESTORE DEFA U LT
SYSTEM SETTINGS? Press S E L E C T the following will appear on the display.
If you are sure you wish to restore all line settings, press SELECT again.
Information Retention During a Power Loss
Soundpoint Pro retains all stored information during loss of power. It is not necessary to
reset any programmed or stored parameters.
CAUTION: SoundPoint Pro will not operate without power. See the “Safety
Instructions” on Page ii for precautions.
SoundPoint Pro Professional Conference Phone Operation
2 –2 4