GETTING STARTED GUIDE FOR THE VSX SERIES
WWW.POLYCOM.COM/VIDEODOCUMENTATION
28
To use the chair control options when you are in a multipoint call:
1. On a PC, open a web browser.
2. In the browser address line, enter the system’s IP address, for
example, http://255.255.255.255
, to go to the video conferencing
system’s web interface.
3. Click Place a Call.
4. Click Chair Control to go to the Chair Control screen.
The Chair Control option is only available when the system is in a multipoint call. It
is not available in cascaded multipoint calls.
5. Select a site from the list and then use the controls in the web interface
to perform one of these actions:
If you
are…
You can Do This… By Selecting…
Pass chair controls to the selected
site
Release Chair
View the selected site’s video. This
does not change what other sites
see.
View Site
Return to viewing the video selected
by the chair or by the MCU
Stop Viewing
Site
Send your site’s video to the other
sites
Make Me the
Broadcaster
Send the selected site’s video to the
other sites
Select
Broadcaster
Remove the selected site from the
conference
Disconnect
Site
Chair
controller
Disconnect all sites and end the call. End
Conference
Request control of the conference Acquire Chair
View the selected site’s video. This
does not change what other sites
see.
View Site
Participant
Return to viewing the video selected
by the chair or the MCU
Stop Viewing
Site
To Next Page
Loading...
Need help?
General
