Polyend Tracker - Architecture

Granular Position,
Finetune,
Automation type:
Off,
Envelope with Attack, Decay, Sustain, Release and Amount settings,
LFO with Shape (Rev Saw, Saw, Triangle, Square, Random), Speed (from 24 to
1/64 steps for Volume value and from 128 to 1/64 steps for all the other
destinations) and Amount settings.
Important:
The LFO speed is always hard synced with the project tempo.
The number indicating the speed of LFO is corresponding to steps. For example Speed
= 16 means that one LFO cycle will last for 16 steps.
To change/choose an instrument from Instrument Parameters screen quickly – press
and hold the yellow Instrument key and a pop-up list of instruments will appear.
From step to pattern
Use thePattern modein order to create musical sequences by simply placing steps
consisting of Note/Instruments/Fx1/Fx2 + their values as events appearing in time.
This is the Tracker’s main screen, the one you will be spending most time working with and
probably the most important one – the step sequencer view with the classic tracker vertical
layout. Create project patterns here. Store up to 255 of them per project. Each pattern
consists of 8 audio/MIDI tracks which can be from 1 to 128 steps long.
Hold down the Pattern screen button to see the occupied/stored patterns/pads.
Each track is both audio and MIDI at the same time. Step properties determine if the internal
sample-based instrument or external MIDI instrument will get triggered (explained in the
section below).
Pattern view playback modes:
Press Play > play the pattern from the 1st step,
Press Shift + Play > play pattern from the currently highlighted step,
Press Song + Play > play the song arrangement.