21
UFH8ZMP
VIII. Software update
WARNING
Software update shall be conducted only by a qualifi ed fi tter. After the software
has been updated, it is not possible to restore previous settings.
In order to install new software, the controller must be unplugged from the power supply.
Next, insert the memory stick with the new software into the USB port. Connect the
controller to the power supply at the same time holding EXIT button. It is necessary
to hold EXIT button until a single sound signal is heard – it signalises that the software
update process has been initiated. After it has been completed, the controller restarts
automatically.
WARNING
Do not switch the controller off while updating the software.
To Next Page
Loading...
