Polytec OFV-512 User Manual


0DNLQ J0HDVXUHPHQWV
'LV SOD\LQJW KH2XW SX W6 LJQD OV
To display the output signals, proceed as follows:
9HORFLW\
VLJQDO
1. Connect an oscilloscope to the BNC jack VELOCITY OUTPUT on the
front of the controller.
:LWKDVXLWDEOHVHOHFWHGPHDVXUHPHQWUDQJHWKHH[SHFWHGVLJQDOIRUP
VKRXOGEHYLVLEOHDWWKH9(/2&,7<287387
2. Select the next highest measurement range if the L ED OVER is continu-
ously lit up at the front of the controller (refer to section 4.2.2).
7KHQWKHPD[LPXPYHORFLW\H[FHHGVWKHIXOOVFDOHUDQJH7KHGLVSO D\
PD\OLJKWXSEULHIO\ZKLOHDGLIIHUHQWYHORFLW\P HDVXUHPHQWUDQJHLV
EHLQJVHWRUGXHWRQRLVHVSLNHV
3. Increase the intensity of the light scattered back by various surface mate-
rials.
7KHQRLVHOHYHORIWKHYHORFLW \RXWSXWGHFUHDVHV7KHPLQLP XPQRLVH
OHYHOVKRZVWKHRSWLPDODOLJQPHQWDQGIRFXVLQJIRUWKHVXUIDFHTXDOLW\
SUHVHQW
'LVSODFHPHQW
VLJQDO
RSWLRQDO
4. Connect an oscilloscope to the BNC jack DISPLACEMENT OUTPUT on
the front of the controller.
$WW KH',63/$&(0(17287387DVDJHQHUDOU XOHWKHH[SHFWHGVLJQDO
IRUPFDQQRWEHVHHQLQLWLDOO\
5. Press the CLEAR key several times.
$IWHUSUHVVLQJWKHNH\VHYHUDOW LPHVWKHH[SHFWHGVLJQDOIRUPVKRXOGEH
YLVLEOHRQWKHRVFLOORVFRSHUHIHU WRVHFWLRQ &/($5IXQFWLRQ,I
QRWWKHQWKHGLVSODFHPHQWPHDVXUHPHQWUDQJHLVXQVXLWDEOHDQGVKRXOG
EHVHOHFWHGDFFRUGLQJWRWKHLQIRUP DWLRQSURYLGHGLQVHFWLRQ 
6LJQ
FRQYHQWLRQ
The following sign convention for direction applies to the output signals:
A movement WRZDUGV the sensor head is considered as being SRVLWLYH . In
this case the velocity output voltage is positive and the displacement output
voltage is increasing.

Polytec OFV-512 Specifications

General

Brand	Polytec
Model	OFV-512
Category	Measuring Instruments
Language	English