For an initial functional test of the PSV you proceed as follows:For an initial functional test of the PSV you proceed as follows:
1.1. InsInstatall tll the Phe PSV SV as das descescribribed ied innse
sectictionon 3.43.4..
2.2. Make suMake sure that thre that the key swie key switch on the ctch on the controntroller is ioller is in positn position O and tion O and thehe
beam shutter on the scanning head is in position OFF.beam shutter on the scanning head is in position OFF.
3.3. PosiPosition thtion the scane scanning heaning head roughd roughly sucly such that ith that its lases laser beam aper beam aperturrturee
points to a test surface.points to a test surface.
4.4. SwitSwitch the cch the controntroller ooller on by turn by turning tning the key she key switwitch to poch to positisition I.on I.
5.5. SwitSwitch on the wch on the workstorkstationation, sta, start the PSrt the PSV sofV softwartware and change and change to thee to the
Acquisition Mode as described in your Acquisition Mode as described in your softwasoftware manual.re manual.
6.6. BefoBefore now openre now opening the beaing the beam shuttm shutterer, remem, remember the infber the informatormation on laseion on laserr
safety provided insafety provided inse
sectictionon 1.11.1!!
7.7. Open tOpen the dushe dust covt cover and ther and the beam se beam shutthutter of ther of the scane scanning heaning head.d.
8.8. TTest the est the function function of the sof the scanning head canning head controls (controls (focus and focus and position position of theof the
laser beam, zoom and focus of the video camera, movement of the pan-tiltlaser beam, zoom and focus of the video camera, movement of the pan-tilt
stage) as described in your software manual.stage) as described in your software manual.
9.9. Put a matt whPut a matt white test suite test surfacrface, e.g. a piece, e.g. a piece of papere of paper, at appro, at approximaximatelytely
2020 cm from the front panel of the scanning head in the cm from the front panel of the scanning head in the beam path.beam path.
10.10. Focus the laser bFocus the laser beam on the test seam on the test surface.urface.
If the functional test has been successful you can now make measurementsIf the functional test has been successful you can now make measurements
as described inas described inch
chapapteterr 44..
If your PSV does not If your PSV does not perform as described above, read through theperform as described above, read through the
information on fault diagnosis provided ininformation on fault diagnosis provided inch
chapapteterr 66and, if necessary, contactand, if necessary, contact
your local your local Polytec representativePolytec representatives.s.
To Next Page
Loading...
