The hand set PSV-Z-051 is connected to the circular jack REMOTEThe hand set PSV-Z-051 is connected to the circular jack REMOTE
CONTROL on the front of the scanning head. You can focus the laser beamCONTROL on the front of the scanning head. You can focus the laser beam
using the emphasized part of the hand set shown inusing the emphasized part of the hand set shown infifigugurere 5.5.11..
Using the two arrow keys FAR and NEAR, the laser beam is focused asUsing the two arrow keys FAR and NEAR, the laser beam is focused as
follows:follows:
If you press the keys If you press the keys for more than approximately one second, the for more than approximately one second, the motormotor
switches over to fast mode. For fine switches over to fast mode. For fine positioning, the keys can be repeatedlypositioning, the keys can be repeatedly
pressed briefly. At the end of the adjustment range, the motor stopspressed briefly. At the end of the adjustment range, the motor stops
automatically and the respective Lautomatically and the respective L
EDED
FAR or NEAR lights up.FAR or NEAR lights up.
Beside the keys for focusing, there is a Beside the keys for focusing, there is a signal level display which helps you tosignal level display which helps you to
optimize the focus. The signal shown is identical to optimize the focus. The signal shown is identical to that on the that on the scanning headscanning head
and on the display of the controller.and on the display of the controller.
Figure 5.1: Focusing the laser beam using the hand set PSV-Z-051Figure 5.1: Focusing the laser beam using the hand set PSV-Z-051
use the hand set PSV-Z-051 together with the optional hand set OFV-310 (refer touse the hand set PSV-Z-051 together with the optional hand set OFV-310 (refer to
secsectitionon A.A.33)) !!
FFooccuussiinng g oon n iinnffiinniittyy:: kkeeyy
↑↑
FARFAR
FFooccuussiinng g cclloossee--uupp:: kkeeyy
↓↓
NEARNEAR
To Next Page
Loading...
