When the PSV is controlled via the software (LWhen the PSV is controlled via the software (L
EDED
s REMOTE and LLO are lits REMOTE and LLO are lit
up), you can use the software to focus the laser beam, please refer to yourup), you can use the software to focus the laser beam, please refer to your
software manual.software manual.
When the controller is operated without the software, you can focus the laserWhen the controller is operated without the software, you can focus the laser
beam via the menu FOCUS (refer tobeam via the menu FOCUS (refer tose
sectctionion 5.5.12.12.33).).
To focus the laser beam, you can also use the optional hand set OFV-310To focus the laser beam, you can also use the optional hand set OFV-310
instead of the hand set PSV-Z-051 (refer toinstead of the hand set PSV-Z-051 (refer tosec
sectiotionn A.3A.3).).
The signal level display helps you to The signal level display helps you to optimize the focus of the optimize the focus of the laser beam.laser beam.
The signal level is shown as a bar dThe signal level is shown as a bar display:isplay:
on the back of the on the back of the scanning headscanning head
on the display of the controlleron the display of the controller
in the software (refer to your in the software (refer to your software manual)software manual)
on the hand set PSV-Z-051 (refer toon the hand set PSV-Z-051 (refer tosec
sectiotionn 5.65.6))
on the optional hand set OFV-310 (refer toon the optional hand set OFV-310 (refer tosec
sectiotionn A.3A.3).).
To Next Page
Loading...
