The hand set PSV-Z-051 is connected to the circular jack REMOTEThe hand set PSV-Z-051 is connected to the circular jack REMOTE
CONTROL on the front of the scanniCONTROL on the front of the scanning head. You ng head. You can position thcan position the laser beame laser beam
using the clearly visible part of the hand set shown inusing the clearly visible part of the hand set shown infi
figugurere 5.5.22. To do so,. To do so,
proceed as follows:proceed as follows:
1.1. SwiSwitch on ttch on the worhe workstkstatioation and stn and start thart the PSV e PSV softsoftware.ware.
2.2. ChanChange to the Age to the Acquicquisitisition Mode as don Mode as descrescribed in yoibed in your sofur softwartware manuae manual.l.
3.3. PresPress the Ms the MODE kODE key on they on the hand se hand set to seet to select tlect the kinhe kind of movd of movemenement.t.
You move the laser beam on already defined scan points using the arrowYou move the laser beam on already defined scan points using the arrow
keys. The order in keys. The order in which the software approaches the scan points iswhich the software approaches the scan points is
determined by an internal algorithm. Using the determined by an internal algorithm. Using the keyskeys
→→
oror
↑↑
, you move the, you move the
laser beam forwards along the laser beam forwards along the scan points and backwards using the keysscan points and backwards using the keys
←←
oror
↓↓
. If you press the HOME key. If you press the HOME key, the laser beam is positi, the laser beam is positioned on the first scanoned on the first scan
point.point.
Figure 5.2: Positioning the laser beam using the hand set PSV-Z-051Figure 5.2: Positioning the laser beam using the hand set PSV-Z-051
The longer you hold the arrow key pressed, the faster the laser beam moves!The longer you hold the arrow key pressed, the faster the laser beam moves!
To Next Page
Loading...
