In normal operation the keys FUNCTION and SETTING on the controller areIn normal operation the keys FUNCTION and SETTING on the controller are
deactivated and all settings are adjusted via the software. It is also possible todeactivated and all settings are adjusted via the software. It is also possible to
make measurements withoumake measurements without using the t using the workstatiworkstation. In this case on. In this case you can onlyyou can only
make single-point measurementmake single-point measurements and you s and you can not make use can not make use of the digital dataof the digital data
processing of the PSV. The velocity signal is then available at the BNC jackprocessing of the PSV. The velocity signal is then available at the BNC jack
VELOCITY OUTPUT on the front of the controller.VELOCITY OUTPUT on the front of the controller.
The controller is operated via a menu on its display using the keysThe controller is operated via a menu on its display using the keys
FUNCTION and SETTING. The operating structure is mainly self-explanatory.FUNCTION and SETTING. The operating structure is mainly self-explanatory.
The individual menus are described inThe individual menus are described inse
sectctionion 5.15.12.32.3..
The menu SETTINGS is shown inThe menu SETTINGS is shown infifigugurere 5.5.44as an example of the display.as an example of the display.
Figure 5.4: Example of the controller’s displayFigure 5.4: Example of the controller’s display
The parameters are run through vertically on The parameters are run through vertically on the display using the keysthe display using the keys
↑↑
andand
↓↓
. Once the end of the display page is reached, it changes to the . Once the end of the display page is reached, it changes to the nextnext
menu. The possibility of branching off to other menus is shown at the top andmenu. The possibility of branching off to other menus is shown at the top and
the bottom on the right.the bottom on the right.
The cursorThe cursor
⇒⇒
on the left marks a selected parameter. The setting of theon the left marks a selected parameter. The setting of the
parameter is changed to higher and lower values with the keysparameter is changed to higher and lower values with the keys
++
andand
−−
..
Adjusted settings are activated straight away.Adjusted settings are activated straight away.
As the control processor has a battery supported memory, the settings areAs the control processor has a battery supported memory, the settings are
stored when the instrument is switched off and reloaded when it is switchedstored when the instrument is switched off and reloaded when it is switched
on again or after RESET. This saves time making adjustments for repeatedon again or after RESET. This saves time making adjustments for repeated
measurements.measurements.
Using Using the the keyskeys
↑↑
andand
↓↓
a menu is a menu is selected and within the menuselected and within the menu
a parameter is selected.a parameter is selected.
Settings Settings are are changed changed using using the the keyskeys
++
andand
−−
..
FocusFocus
↑↑
⇒⇒
TTrraacckkiinng g FFiilltteerr FFaasstt
VVeelloocciitty y DDeeccooddeerr HHFF
VVeelloocciitty y RRaannggee 11225 5 mmmm//ss//VV
VVeelloocciitty y FFiilltteerr oofff f ((11..5 5 MMHHzz))
SSiiggnnaall
ConfigConfig
↓↓
To Next Page
Loading...
