55.. ReRepepeaat t ststepepss33andand44until all desired scan points are defined.until all desired scan points are defined.
To delete defined scan points, select the GRID mode using the MODE key onTo delete defined scan points, select the GRID mode using the MODE key on
the hand set (Lthe hand set (L
EDED
GRID is lit up). The TEACH key now functions as DEL keyGRID is lit up). The TEACH key now functions as DEL key
(for deleting).(for deleting).
6.6. UsinUsing the arrog the arrow keyw keys, move ts, move the lasehe laser beam forr beam forwardwards or backs or backwards twards to theo the
scan point you want to delete.scan point you want to delete.
7.7. PresPress the Ds the DEL keEL key and thy and the selece selected scted scan poinan point is delet is deleted.ted.
88.. ReRepepeaat t ststepepss6
6andand77until all desired scan points are deleted.until all desired scan points are deleted.
When the PSV is controlled via the software (LWhen the PSV is controlled via the software (L
EDED
s REMOTE and LLO are lits REMOTE and LLO are lit
up), you can use up), you can use the software to define and delete the software to define and delete scan points, please refer toscan points, please refer to
your software manual.your software manual.
When the PSV is controlled via the software (LWhen the PSV is controlled via the software (LEDEDs REMOTE and LLO are lits REMOTE and LLO are lit
up), all settings are adjusted via up), all settings are adjusted via the software, refer to your software manual.the software, refer to your software manual.
In this case the In this case the keys FUNCTION and SETTINkeys FUNCTION and SETTING on the G on the front of the controllerfront of the controller
do not have a function.do not have a function.
You will find information on setting the measurement range and the filters inYou will find information on setting the measurement range and the filters in
sec
sectitionon 4.24.2..
When the controller is operated without the When the controller is operated without the softwaresoftware, you can , you can set theset the
measurement range and the filters via a menu on its display using the keysmeasurement range and the filters via a menu on its display using the keys
FUNCTION and SETTING (refer toFUNCTION and SETTING (refer tosec
sectiotionn 5.15.122).).
Overranging is indicated in the software. Please refer to your Overranging is indicated in the software. Please refer to your softwaresoftware
manual.manual.
If the LIf the LEDEDOVER on the front of the controller is lit up continuously, it meansOVER on the front of the controller is lit up continuously, it means
that the measurement range set is that the measurement range set is being exceeded. In this case the being exceeded. In this case the nextnext
highest measurehighest measurement range must be selected. Yment range must be selected. You will find further informaou will find further informationtion
on setting the measurement range inon setting the measurement range insec
sectiotionn 4.24.2.1.1..
To get a 3D view style of the data, you have to define connections in the software. PleaseTo get a 3D view style of the data, you have to define connections in the software. Please
refer to your software manual.refer to your software manual.
If you press the DEL key for more than approximately one second, the scan points will beIf you press the DEL key for more than approximately one second, the scan points will be
deleted one after the other!deleted one after the other!
To Next Page
Loading...
