The hand set PSV-Z-051 is connected to the circular jack REMOTEThe hand set PSV-Z-051 is connected to the circular jack REMOTE
CONTROL on the front of the scanning head. You can define and deleteCONTROL on the front of the scanning head. You can define and delete
individual scan points using the clearly visible part of individual scan points using the clearly visible part of the hand set the hand set shown inshown in
fi
figugurere 5.5.33. To do so, proceed as follows:. To do so, proceed as follows:
1.1. SwiSwitch on ttch on the worhe workstkstatioation and stn and start thart the PSV e PSV softsoftware.ware.
2.2. ChanChange to the Age to the Acquiscquisitioition Mode thn Mode then to Defen to Define Scine Scan Poian Points annts and selecd select thet the
Point Mode as described in Point Mode as described in your software manual.your software manual.
To define scan points, select the FREE mode using the MODE key on theTo define scan points, select the FREE mode using the MODE key on the
hand set (Lhand set (LEDEDFREE is lit up).FREE is lit up).
3.3. UsinUsing the four ag the four arrow kerrow keys, moys, move the lave the laser beaser beam to the desm to the desired poired positisition.on.
4.4. PresPress the s the TEATEACH buCH button tton and thand the scae scan poinn point is det is definedfined..
Defining and deleting individual scan points is only available if you have the software optionDefining and deleting individual scan points is only available if you have the software option
APS Professional (PSV-Z-062)!APS Professional (PSV-Z-062)!
Figure 5.3: Defining and deleting scan points using the hand set PSV-Z-051Figure 5.3: Defining and deleting scan points using the hand set PSV-Z-051
To Next Page
Loading...
