After being switched on or RESET, the controller shows that it is ready toAfter being switched on or RESET, the controller shows that it is ready to
operate with the menu INTRO. It is not possible to change back to this menuoperate with the menu INTRO. It is not possible to change back to this menu
as it does not have a as it does not have a control function.control function.
This menu provides information on the This menu provides information on the decoders and interfaces installed. Thedecoders and interfaces installed. The
individual configurations are described in the following.individual configurations are described in the following.
This line shows the velocity decoders installed and the This line shows the velocity decoders installed and the number of availablenumber of available
velocity measurement ranges. The following abbreviationvelocity measurement ranges. The following abbreviations are used s are used for thefor the
individual decoders:individual decoders:
Example:Example:
3DC + 4HF means that the veloci3DC + 4HF means that the velocity decoder PLL-DC wty decoder PLL-DC with 3ith 3 measurementmeasurement
ranges and the velocity decoder OVD-04 with 4 ranges and the velocity decoder OVD-04 with 4 measurement ranges aremeasurement ranges are
installed.installed.
When operating the controller via the IEEEWhen operating the controller via the IEEE-488-488//GPIB interface on the back inGPIB interface on the back in
this line the instrument address can be set in the rangethis line the instrument address can be set in the range
..
When operating the controller via the RS-232 interface on the back When operating the controller via the RS-232 interface on the back in this linein this line
it is possible to switch between the transfer ratesit is possible to switch between the transfer rates
andand
..
Table 5.1: Abbreviations of the individual velocity decodersTable 5.1: Abbreviations of the individual velocity decoders
DDCC PPLLLL--DDCC
HHFF OOVVDD--0044
If you control the PSV using the software via the IEEE-488/GPIB interface, theIf you control the PSV using the software via the IEEE-488/GPIB interface, the
IEEE-488/GPIB address of the controller must be set toIEEE-488/GPIB address of the controller must be set to
!!
For all PSV models, here the transfer rate must be set toFor all PSV models, here the transfer rate must be set to !!
To Next Page
Loading...
