Polytec PSV 300

To Next Page

To Previous Page



        

                         





In the menu SETTINGS the measurement ranges and filters are set. In the menu SETTINGS the measurement ranges and filters are set. TheThe

contents of the menu depends on contents of the menu depends on the decoders installed. The individualthe decoders installed. The individual

settings have the settings have the following meaning.following meaning.

  

In this line you In this line you can set the tracking filter. The input signal is can set the tracking filter. The input signal is pre-processepre-processedd

with the tracking filter. You will find information on the settingswith the tracking filter. You will find information on the settings ////

of the tracking filter inof the tracking filter inse

sectctionion 4.24.2.3.3..

  

In this line you In this line you can set the active velocity decoder. This line is only can set the active velocity decoder. This line is only present ifpresent if

both decoders OVD-04 and PLL-DC are installed. The velocity decoders areboth decoders OVD-04 and PLL-DC are installed. The velocity decoders are

abbreviated as described above inabbreviated as described above intatablblee 5.5.11..

  

In this line you In this line you can set the velocity measurement range. The possible settingscan set the velocity measurement range. The possible settings

depend on the velocity decoder selected. You will find information on settingdepend on the velocity decoder selected. You will find information on setting

the velocity measurement range inthe velocity measurement range insec

sectiotionn 4.24.2.1.1..

  

In this line you can set the cutoff frequency of the low pass filter. The possibleIn this line you can set the cutoff frequency of the low pass filter. The possible

settings depend on the PSV model. In position OFF, the upper frequency limitsettings depend on the PSV model. In position OFF, the upper frequency limit

of the active velocity decoder is shown. You will find information on setting theof the active velocity decoder is shown. You will find information on setting the

low pass filter inlow pass filter insec

sectiotionn 4.24.2.2.2..



This line shows the optical signal level as a bar display.This line shows the optical signal level as a bar display.

   In this menu, the laser beam is focused using theIn this menu, the laser beam is focused using the

−−

andand

keys. Thekeys. The

movement of the motor to position the front lens is movement of the motor to position the front lens is shown on the display of theshown on the display of the

controller with following controller with following symbols:symbols:

The bar in the lower line The bar in the lower line of the display shows the optical signal level.of the display shows the optical signal level.





If If ththe De DC dC decoecoder der is is seselelectected ad and nd ththe vee velolocitcity my meaeasusuremremenent rt rangange 1 e 1 is is setset, i, it it is nos nott

possible to change to the HF decoder because the HF decoder does not have this velocitypossible to change to the HF decoder because the HF decoder does not have this velocity