Simple tests are described in the following which you can carry out Simple tests are described in the following which you can carry out yourself inyourself in
the case of the case of malfunctiomalfunction. In the n. In the case of more difficult faults in individualcase of more difficult faults in individual
functions, please contact our service personnel. The tests described here arefunctions, please contact our service personnel. The tests described here are
not meant to lead you to carry out not meant to lead you to carry out maintenance work yourselmaintenance work yourself but to providef but to provide
our service personnel with information which is as our service personnel with information which is as accurate as possible.accurate as possible.
Testing the PSV is limited to such tests in which the housing does not have toTesting the PSV is limited to such tests in which the housing does not have to
be opened. Opening the housing be opened. Opening the housing without authorization invalidatwithout authorization invalidates thees the
warranty.warranty.
If required, please contact our service department. Based on your faultIf required, please contact our service department. Based on your fault
description, further procedure will be description, further procedure will be determined.determined.
If the PSV has to be sent back for repair, please use the original packagingIf the PSV has to be sent back for repair, please use the original packaging
and enclose an and enclose an exact description of the fault.exact description of the fault.
If any system component of the PSV does not function properly, please firstIf any system component of the PSV does not function properly, please first
check the following:check the following:
1.1. Is tIs the Phe PSV cSV correcorrectly ctly cabled abled as deas descriscribed ibed innsec
sectiotionn 3.43.4.2.2??
2.2. Are thAre there onlere only origy original Rinal RS-232 cS-232 cables ables from Pfrom Polytolytec useec used (1:1 wd (1:1 wired)?ired)?
3.3. Is tIs the trhe transansfer rfer rate sate set to 9600 Bet to 9600 Bauaud (red (refefer tor tosesectictionon 5.15.12.32.3)) ??
4.4. If yoIf you contu control the Prol the PSV usSV using thing the softe software vware via the Iia the IEEEEEE-488/-488/ GPIGPIBB
interface: Is the IEEinterface: Is the IEEE-488E-488//GPIB address of the contGPIB address of the controller set to 5 (refer toroller set to 5 (refer to
se
sectictionon 5.15.12.2.33))??
Check whether the data acquisition board is correctly installed. To do so,Check whether the data acquisition board is correctly installed. To do so,
proceed as follows:proceed as follows:
5.5. DoubDouble-clle-click the iick the icon Meacon Measuremsurement&ent&AutoAutomatimation on the deon on the desktosktop.p.
6.6. ChanChange inge into thto the fole folder Dder Devicevices aes and Innd Interfterfaces.aces.
To Next Page
Loading...
