Adjusting
the
Speakers
BAL:
Press this knob lightly
so
it extends. Turn this
knob
to
move the sound to the left
or
right speakers.
The middle position balances the sound between
the speakers.
FADE:
Press
this knob lightly
so
it extends. Turn this
knob to move the sound to the front or rear speakers.
The middle position balances the sound between
the speakers.
Push these knobs back into their stored positions when
you’re
not
using
them.
Playing
a Cassette
Tape
Your tape player is built to work best with tapes that are
30
to
45
minutes long
on
each side. Tapes longer than
that are
so
thin they may not work well in this player.
While the tape is playing, use the
VOL,
FADE,
BAL,
BASS
and
TREB
controls just as you do
for
the radio.
The display will
show
an arrow to show which side
of
the tape
is
playing. When the down indicator arrow
is
lit, selections listed on
the
bottom side
of
the cassette are
playing, When the up arrow is lit, selections listed
on
the
top side
of
the cassette
are
playing. The tape player
automatically begins playing the other side when it
reaches the end
of
the tape.
If
E
and a number appear on the radio display, the tape
won’t play because
of
an error.
0
E10:
The tape is tight and the player can’t turn the
tape hubs. Remove the tape. Hold the tape with
the open end down and try to turn the right hub
counterclockwise with
a
pencil. Turn the tape over
and repeat.
If
the hubs
do
not turn easily, your tape
may be damaged and should not be used in the
player. Try a new tape to make sure your player is
working properly.
Ell:
The tape is broken. Try
a
new tape.
If
any error occurs repeatedly or if an error can’t be
corrected, please contact your dealer.
If
your radio
displays
an
error number,
write
it
down
and
provide
it
to
your dealer when reporting the problem.
PREV
(I):
Press this button or the
SEEK
down arrow to
search
for
the previous selection on the tape. Your tape
must have at least three seconds
of
silence between each
selection for
PREV
or
SEEK
to work. The tape direction
arrow blinks during
PREV
or
SEEK
operation. Press
PREV
or
the
SEEK
down arrow
to
stop searching. The
sound
will
mute during
PREV
or
SEEK
operation.
To Next Page
Loading...
Need help?
General
