NEXT
(2):
Press this button or the
SEEK
up arrow
to
search for the next selection on the tape. If
you
hold the
button, the player will continue moving forward through
the tape. Your tape must have at least three seconds of
silence between each selection for NEXT or SEEK to
work. The tape direction arrow blinks during NEXT or
SEEK operation. Press NEXT or the SEEK up arrow to
stop searching. The sound will mute during NEXT or
SEEK
operation.
PROG
(3):
Press this button to play the other side
of the tape.
130
(4):
Press this button to reduce background noise.
Note that the double-D symbol will appear on the display.
Dolby@
Noise Reduction is manufactured under
a
license from Dolby Laboratories Licensing Corporation.
Dolby and the double-D symbol are trademarks of
Dolby Laboratories Licensing Corporation.
REV
(5):
Press
this
button
to
reverse
the
tape rapidly.
Press it again to return to playing speed. The radio will
play the last-selected station while the tape reverses.
You
may select stations during
REV
operation by using
SEEK
or TUNE.
FWD
(6):
Press this button to advance quickly
to
another part
of
the tape.
Press
the button again to return
to playing speed. The radio will play the last-selected
station while the tape advances. You may select stations
during FWD operation by using SEEK or TUNE.
AM-FM:
Press this button to play the radio
when
a
tape
is
in
the
player.
TAPEPLAY
Press this button to change
to
the tape
function when the radio is on. The tape symbol with an
arrow will appear on the display when the tape
is
active.
To return to playing the radio, press the
AM-FM
button.
EJECT
Press this button to remove the tape. The radio
will play. EJECT may be activated with either the
ignition
or
radio
off.
Cassettes may
be
loaded
with
the
radio and ignition off if this button is pressed first. If
you leave a cassette tape in the player while listening to
the radio,
it
may become warm.
CLN:
If
this message appears
on
the
display,
the
cassette tape player needs
to
be cleaned. It will
still
play
tapes, but you should clean it as soon
as
possible to
prevent damage to the tapes and player. See “Care
of
Your Cassette Tape Player” in the Index. After you clean
the
player, press and hold EJECT
for
five
seconds
to
reset the CLN indicator.
The
radio will display
---
to
show the indicator was reset.
3-9
To Next Page
Loading...
Need help?
General
