Playing the Radio
VOL:
Push this knob to turn the system on and off.
To
increase volume, turn the knob clockwise. Turn it
counterclockwise to decrease volume.
RECALL:
Display the time with the ignition
off
by
pressing this knob. When the radio is playing, press this
knob to recall the station frequency.
Finding
a
Station
AM-FM:
Press this button
to
switch between
AM,
FM1
and
FM2.
The display shows your selection.
TUNE:
Press this knob lightly
so
it extends. Turn it to
choose radio stations. Push the knob back into its stored
position when you’re not using it.
SEEK:
Press the up or down arrow
to
go
to the next
higher or lower station and stay there.
PUSHBUTTONS:
The six numbered pushbuttons let
you return to your favorite stations.
You
can set up to
18
stations (six
AM,
six
FM1
and six
FM2).
Just:
1.
Turn the radio on.
2.
Press
AM-FM
to select the band.
3.
Tune in
the
desired station.
4.
Press and hold one of the six numbered buttons until
SET
appears
on
the display. Whenever you press that
numbered button, the station you set will return.
5.
Repeat the steps
for
each pushbutton.
Setting the Tone
EQUALIZER: A
seven band equalizer is part
of
your
audio system. Slide the levers up to boost or down
to
reduce frequency range.
Adjusting the Speakers
BAL:
Press this knob lightly
so
it extends. Turn it to
move the sound to the left or right speakers. The middle
position balances
the
sound between the speakers.
FADE:
Press this knob lightly
so
it extends. Turn
it
to
move the sound to the front or rear speakers. The middle
position balances the sound between
the
speakers.
Push these knobs back into their stored positions
when
you’re not using them.
Playing
a
Cassette Tape
Your tape player is built to work best with tapes that are
30
to
45
minutes long on e,ach
side.
Tapes
longer
than
that are
so
thin
they may not work well in this play’er.
3-11
To Next Page
Loading...
Need help?
General
