Page 8 www.poolpro.com.au
INITIAL START-UP
Turn on the chlorinator unit by pressing the button. Wait for the chlorinator unit to
run through a start-up sequence.
SETTING THE CLOCK (time of day)
1. “START UP CLOCK SET” will display on the LCD screen.
2. “HH” will ash. Press or to change the hour. Press to save.
3. “MM” will ash. Press or to change the hour. Press to save.
SETTING THE TIMER / RUN PERIOD (daily run times of the chlorinator)
1. “START UP RUN PERIODS” will display on the LCD screen. “2 CYCLES/DAY” will
ash.
2. Press or to scroll through the cycles.
Select from the following cycles for your chlorinator to operate:
(a) “2 CYCLES/DAY” = 6am - 10am and 4pm - 8pm
(b) “1 CYCLE AM” = 8am - 4pm
(c) “1 CYCLE PM” = 8pm - 4am
3. Press to save or press to exit without saving. If these cycle times are not
suitable, you can change them in the Clock/Timer function – see page 11-12.
SETTING UP THE POOL SIZE
1. “START UP INFORMATION” will display on the LCD screen. The litre quantity for
“POOL SIZE” will ash.
2. Press or to change the litre quantity by 1,000L increments, hold or
to change the litre quantity by 5,000L increments.
3. Press to save or press to exit without saving.
SETTING UP THE MINERAL TYPE (if your pool uses salt or mineral mix)
1. “START UP INFORMATION” will display on the LCD screen. “SALT” will ash.
2. Press or to change the type of mineral used in the pool water. Select from
“SALT” or “MINERAL MIX”.
3. Press to save or press to exit without saving.
To Next Page