What to do if my Pope 101PLT25FC Trimmer engine does not reach full speed?
If your Pope Trimmer engine isn't reaching full speed, try these steps: 1. Make sure you're using fresh fuel and the correct 2-stroke oil mix. 2. Check and clear the air filter. 3. Clean the spark arrestor screen.
How to fix Pope 101PLT25FC Trimmer line that won't advance automatically?
If the line on your Pope Trimmer isn't advancing automatically, consider these potential solutions: * Lubricate the line with silicone spray if it's welded to itself. * Install more line onto the spool if there isn't enough. * If the line is worn too short, pull the line while pressing down on and releasing the retaining cap. * Remove the line from the spool and rewind it if it's tangled. * Ensure the engine is at full throttle when advancing the line.
Why is oil dripping from my Pope 101PLT25FC motor?
If oil is dripping from your Pope Trimmer motor, it could be due to: * Operating the product at part throttle. Operate the product at full throttle. * Incorrect oil/fuel mixture. Use fresh fuel and the correct 2 stroke oil mix. * A dirty air filter. Clean the air filter.
What to do if grass wraps around the Pope 101PLT25FC head?
If grass is wrapping around the trimmer head assembly and attachment shaft of your Pope Trimmer: * Avoid cutting tall grass at ground level; instead, cut from the top down. * Ensure you're operating the product at full throttle.
How to loosen a hard-to-turn retaining cap on a Pope Trimmer?
If the retaining cap is hard to turn when using automatic line lengthening on your Pope Trimmer, the screw threads may be dirty or damaged. Clean the threads and lubricate them with grease. If the problem persists, consider replacing the retaining cap.
Why won't my Pope Trimmer engine start?
If your Pope Trimmer engine won't start, here are a few things to check: * Ensure the switch is in the ON position. * Check for a spark by removing the spark plug, re-attaching it, and laying it on the metal cylinder. Pull the starter cord to look for a spark. Replace the spark plug if there's no spark. * Push the primer bulb until it's full of fuel. If it doesn't fill, there may be a blockage in the fuel delivery system. * If the engine is flooded, remove the spark plug and turn the trimmer so the spark plug hole faces the ground. Set the choke lever to B and pull the starter cord 10-14 times. Clean and reinstall the spark plug. Then, with the trigger fully depressed, pull the starter cord three times. If it still doesn't start, set the choke lever to full and try normal starting...
Steps to connect the upper shaft with engine to the lower bent shaft cutting head.
Instructions for attaching the front handle to the upper shaft.
Steps for attaching the grass deflector shield to the lower shaft.
Instructions on how to correctly mix petrol and 2-stroke oil for the engine.
Steps for safely refuelling the line trimmer's fuel tank.
Covers starting cold, warm, and flooded engines, including preparatory steps and procedures.
To Next Page
General