To Advance the Cutting Line
Follow these steps to advance the cutting line.
The cutting line is advanced by tapping the cutting head
on grass while running the engine at full throttle.
Run engine at full throttle.1.
Tap the spool retainer on ground to advance line. 2.
The line advances each time the spool retainer
is tapped.
NOTE: The line trimming cut-off blade on the grass
defl ector will cut the line to the correct length.
To Advance the Cutting Line Manually
Follow these steps to advance the cutting line manually.
Stop the engine.1.
Push the spool retainer down while pulling on the 2.
nylon line(s) to manually advance the line.
Grass Deflector Line Trimming Cut
Off Blade
The trimmer is equipped with a line trimming 1.
cut-off blade on the grass deflector.
For best cutting, advance line until it is trimmed 2.
to length by the cut-off blade.
Advance the line whenever you hear the engine 3.
running faster than normal, or when trimming
efficiency diminishes. This will maintain best
performance and keep the line long enough to
advance properly.
Operation -
continued
Maintenance
Emissions Maintenance Schedule
Maintenance, replacement or repair of the emission
control device and systems may be performed by any
recognised Toro or Pope Service Centre.
Before performing any maintenance on this
machine, stop the engine and disconnect the
spark plug wire.
WARNING:
Before Each Use
Remove dirt and debris from the product exterior.1.
Inspect the engine, tank and hoses for possible fuel 2.
leaks and repair as necessary.
Inspect the engine cooling fi ns for accumulation of 3.
debris and clean as necessary.
Inspect the entire machine for damage, loose 4.
or missing components or fasteners and repair as
necessary.
Cleaning the Product
Stop the product before cleaning.1.
Clean the exterior of the product with a damp cloth.2.
Avoid using solvents when cleaning plastic parts. 3.
Most plastics are susceptible to damage from
various types of commercial solvents and may be
damaged by their use.
Emission Part Inspect
Before
Each Use
Every
10
Hours
Every 10-
15 hours
or
Yearly
Fuel Tank Assembly
(includes Fuel Line,
Fuel Cap and Fuel
Filter)
X
Clean Air Filter X X
Replace Spark Plug X
14
To Next Page
Loading...