Porkka Future Plus - CLEANING AND MAINTENANCE; Routine Cleaning Procedures; Important Cleaning Warnings

Clean condenser (Future C, M, F):
-vacuum the condenser with
careful up-and-down strokes
(B)
Clean condenser (option, Future C, M, F):
-the condenser is behind the
control panel
-loosen two screws on the
lower part of the panel (A)
-open the panel and vacuum
the condenser with careful
up-and-down strokes (B)
or clean fi lter (Future Plus):
-pull out the fi lter casing
-remove and wash the fi lter
-after it has dried, install the
fi lter back to the casing
ENGLISH
7
CLEANING AND MAINTENANCE
Clean spillages immediately.
Ensure effective operation of the equipment and the quality of
the stored products by defrosting and cleaning the equipment
once a month at least.
Remove all food and store it in a back-up store.
Switch off the unit from the main electrical power
switch and take off the electric wire from the wall socket.
Remove shelves and GN rails as well as drawers and runners
(and shelf support uprights).
Wash the stainless steel surfaces of the equipment by a mild
detergent mixed with water *, e.g. dishwasher detergent
or other suitable detergent. Use a cloth or a paper towel to
prevent scratching.
RINSE WITH A DAMP CLOTH, DRY AND ALLOW THE
CABINET TO DRY OUT.
* DO NOT USE DETERGENTS OR DESINFECTANTS
CONTAINING CHLORINE, SOLVENTS, SCRUBBING
PRODUCTS, A KNIFE OR OTHER SHARP TOOLS.
DO NOT USE RUNNING WATER TO WASH THE CABINET.
REFER TO THE PRODUCT DESCRIPTION OF THE
DESINFECTANT TO SEE WHICH MATERIALS IT IS
SUITABLE FOR. DO NOT LET IT SPLASH ON SENSITIVE
PARTS, SUCH AS THERMOSTAT REGULATOR OR DOOR
HINGES. DRY THE EQUIPMENT AFTER THE
DESINFECTION AND LET IT VENTILATE.
Clean the condenser and/or condenser fi lter.
Clean the cabinet door gasket using a mild water soluble
detergent and check the condition of the gasket. A silicone
spray makes the gaskets fl exible and dirt-rejecting.
Lubricate the drawer runners with lubricant suitable for
foodstuff.
Cleaning in dishwasher is not recommendable for the loose
parts of the equipment.
Put back all removed parts and switch on the equipment.
Ensure that the temperature has become to the normal level
before using the equipment again.