Parking 255
Reprogramming an individual button of
keypad A
1. Press the button of keypad A to be repro-
grammed. Do not release the button before
step 4 is executed.
2. When the light-emitting diode B flashes slowly
(after approximately 20 seconds), point the
original transmitter at the position marked.
3. Press the button of the original hand-held trans-
mitter and keep it depressed.
4. The light-emitting diode B first flashes slowly
and then more quickly.
Only release both buttons when light-emitting
diode B flashes quickly.
Operating the garage door opener
f Press the corresponding button on keypad A.
Light-emitting diode B lights up during signal
transfer.
To Next Page
Loading...
Need help?
General
