Body
Page 5.6
Closing The Rear Lid Automatically
Make sure that the load is not too close to the rear lid when closing it
because otherwise the process for closing the rear lid will be aborted
and the rear lid will stop and not fully close and lock.
Press the button in the rear lid trim. Interrupting the opening/closing
process in dangerous situations.
The opening/closing process is interrupted immediately if one of
the following buttons/switches is actuated:
• Pressing the button on the key,
or releasing the switch in the driver’s door,
or pressing the button in the rear lid trim,
or pressing the release button on the rear lid.
Automatic opening/closing can be resumed at any time. To do this,
simply actuate the relevant button/switch.
Obstacle Detection While Opening The Rear Lid
If the opening process is blocked by an obstacle, the rear lid will not
open. An alarm sounds. Once the obstacle is removed, the rear lid can
be opened by pressing the button on the key or pulling the switch in the
driverís door or pressing the release button on the rear lid.
Obstacle Detection When Closing The Rear Lid
If the closing process is blocked by an obstacle, the closing process is
aborted. An alarm sounds and the rear lid remains partially open. Once
the obstacle is removed, the rear lid can be closed by actuating a
button/switch.
Press the button in the rear lid trim. Interrupting
the opening/closing process in dangerous situa-
tions.
To Next Page
Loading...
Need help?
General
