Body
Page 5.7
Setting The Opening Height Of The Rear Lid
The opening height of the rear lid can be set individually, for example, so
that the rear lid will not hit the garage ceiling. The vehicle height
depends on the level settings for vehicles with level control.
Use these steps:
1. Stand behind the vehicle and open the rear lid.
2. Use the button on the key to stop the automatic opening process at
about 2/3 of the opening height.
3. Then move the rear lid up with your hand until it is at the required
opening height. When doing so, make sure the lid is far enough away
from any obstacles.
4. Press the button in the rear lid trim and hold it for approx. 3 seconds.
An acknowledge tone sounds and the direction indicators flash once.
The opening height for the rear lid is now programmed. The rear lid
can now be closed by pressing the button. This setting cannot be
deleted. If a different setting is required, repeat the procedure from
Step 1 to 4.
Malfunction Of The Rear Lid Drive
The automatic function is not active if the battery voltage is too low.
Actuating a button releases the lock on the rear lid and a warning beep
sounds for 3 seconds. The rear lid can now be opened manually.
Notes
A warning beep sounds while the automatic rear lid is moving on
vehicles designed specifically for the USA and Mexico.
Rear Lid Emergency Operation
If the automatic opening/closing process is interrupted due to a fault, a
warning beep sounds for approx. 3 seconds. Open and close the rear lid
manually.
To Next Page
Loading...
Need help?
General
