Porter-Cable CMB15 - Starting and Stopping Procedures; Pre-Operation Checks; How to Start and Stop

14 - ENG
How to Stop
Set the Off/Auto switch to "OFF".

Do not operate this unit until you read this instruction manual


1. Place Off/Auto switch to "OFF" and close air regulator.
2. Plug the power cord into the correct branch circuit receptacle. (Refer to
Voltage and Circuit Protection paragraph in the Installation section of this
manual.)
3. Turn the regulator knob counterclockwise until it stops.
4. Attach hose and accessories.
         
accessories.




roperty damage. 

item that could be damaged by moisture. Some air tools and accessories

accessories.
How to Start
1. Turn the Off/Auto switch to "AUTO" and allow tank pressure to build. Motor
will stop when tank pressure reaches "cut-out" pressure.
2. Turn the regulator knob clockwise until desired pressure is reached. The
compressor is ready for use.