Porter-Cable CMB15 - How to Use Your Unit; Using the High Flow Inflator;Deflator; Inflating Tires and Sport Balls

13 - ENG
HOW TO USE YOUR UNIT


1. Choose nozzle to be used to inflate
(Fig. 4) or deflate (Fig. 5).
2. The high flow inflate/deflate adapt-
er body attachment has an "infla-
tion" outlet and "deflation" outlet.
Attach the nozzle to the preferred
outlet.
3. Insert nozzle into inflatable and
then start inflator, see How to Start
paragraph.
NOTE: If inflatable is not getting firm
enough, place thumb over the "defla-
tion" outlet (Fig. 6) to allow air to go
directly into the inflatable.
   
    
    


outlet.
   
the pressure gauge will not read
correctly. Sometimes the gauge will
read very high. Turn the unit "OFF"
and allow the needle to settle, this

Stop and check the pressure reading

5
Nozzle
attached to

outlet
Nozzle
attached to

outlet
4
6

1. Press female tire chuck onto valve stem.
       
              
valve stem and become a projectile. Use a tire pressure gauge to ensure an


2. See How to Start instructions to start inflator.



1. Insert inflator needle into sport ball to be inflated.
2. PlaceAuto/Offswitchinthe"AUTO"position.Whensportballisfirmplace
Auto/Off switch in the "OFF" position. IMPORTANT: Most sports balls with no
initial air will fill in less than 10 seconds.
NOTE:Whentheunithasbeenturnedoff,itisnormaltohearashorthissofair
being released.