19 - ENG
PROBLEM CAUSE CORRECTION
Compressor is not
supplying enough
air to operate acces-
sories.
Prolonged excessive use of air. Decrease amount of air
usage.
Compressor is not large
enough for air requirement.
Check the accessory air
requirement. If it is higher
than the SCFM or pres-
sure supplied by your air
compressor, you need a
larger compressor.
Hole in hose. Check and replace if
required.
Air leaks. Tighten any exposed
fittings.
Motor will not run. Fuse blown, circuit breaker
tripped.
Check fuse box for blown
fuse and replace as
necessary. Reset circuit
breaker. Do not use a
fuse or circuit breaker
with higher rating than
that specified for your
particular branch circuit.
Check for proper fuse.
You should use a time
delay fuse.
Check for low voltage
problem.
Check the extension
cord.
Disconnect the other
electrical appliances from
circuit or operate the
compressor on its own
branch circuit.
Extension cord is wrong length
or gauge.
Check the extension
cord.
Loose electrical connections. Check wiring connection
inside terminal box.
Faulty motor. Have checked by
a Trained Service
Technician.
To Next Page
Loading...
