Use of this product will expose you to chemicals
known to the State of California to cause cancer, birth defects
and other reproductive harm.
Allowing
dust to get into your mouth, eyes, or lay on the skin may
promote absorption of harmful chemicals.
Use of this tool can generate and/or disburse
dust, which may cause serious and permanent respiratory or other injury. Always use
NIOSH/OSHA approved respiratory protection appropriate for the dust exposure. Direct
particles away from face and body. Always operate tool in well-ventilated area and
provide for proper dust removal. Use dust collection system wherever possible.
ALWAYS USE SAFETY GLASSES. Everyday eyeglasses are NOT safety
glasses. Also use face or dust mask if operation is dusty. ALWAYS WEAR CERTIFIED
SAFETY EQUIPMENT:
• ANSIZ87.1eyeprotection(CAN/CSAZ94.3),
• ANSIS12.6(S3.19)hearingprotection,
• NIOSH/OSHArespiratoryprotection.
ImportantSafetyInstructions.
save these instructions
NAIL SPECIFICATIONS
Nails
0.113"–0.148" (2.87–3.76 mm)
diameter, plastic collated round head framing nails
Lengths
2"–3-1/2"(50–90mm)
Angle
22º
Air Inlet
1/4" NPT (6.4 mm)
Fig. U
To Next Page
Loading...
