Porter-Cable FR350B - Page 3

3 - ENG
          
      
    
     Never use combustible
gases or any other reactive gas as a power source for this
tool. Danger of explosion and/or serious personal injury
may result. (Fig. E)
 
       
         
(Fig. F)
         
       
       
        

    
        

       
 If the contact trip is adjusted when the tool
is connected to the air supply and nails are loaded,
accidental discharge may occur. (Fig. G)
•        

      
         Do
not load fasteners with the trigger or the contact trip
depressed to prevent unintentional driving.
 
       
           
Do not remove spring from contact trip. Make
daily inspections for free movement of trigger and contact
trip. Uncontrolled discharge could result.
•          
         
     
 Leaking air, damaged parts or missing parts
should be repaired or replaced before use. Refer to
Repairs. (Fig. H)
 (Fig.I)
 
 
   Work safe! Respect the tool as a
working implement. (Fig. J)
•       

When tool is not in use, it should be locked
in a safe place, out of the reach of children.
 





