To Next PageTo Next Page
Need help?Do you have a question about the Porter-Cable PCC790 and is the answer not in the manual?
General| Type | Cordless Brad Nailer |
|---|---|
| Power Source | Battery |
| Voltage | 20V |
| Magazine Capacity | 100 nails |
| Depth Adjustment | Yes |
| Tool-Free Jam Release | Yes |
| Nail Gauge | 18 Gauge |
| Nail Length | 5/8" to 2" |
| Firing Mode | Sequential or bump fire |
Crucial warnings for operating power tools safely, covering work area, electrical, and personal safety.
Always wear safety glasses with side shields and appropriate hearing protection.
Always remove battery pack when not in use or performing maintenance.
Do not tamper with trigger/contact trip; inspect for proper function daily.
Use tool only for its intended purpose; do not discharge into hard materials.
Do not use in presence of flammable dust, gases, or fumes.
To reduce injury risk, remove battery and engage trigger lock-off before adjusting depth.
Be aware of dust hazards; use appropriate PPE and ventilation.
Always use NIOSH/OSHA approved respiratory protection for dust exposure.
Always wear proper personal hearing protection conforming to ANSI S12.6.
Read all instructions; avoid liquid, foreign materials, and use only designated chargers.
Do not incinerate, charge in explosive atmospheres, or immerse in liquids.
Avoid contact with battery liquid; seek medical help if contact occurs.
Protect battery terminals from short circuits to prevent fire hazards.
Read safety warnings; wear eye/ear protection; keep nailer pointed away.
Keep fingers from trigger when not driving fasteners; never carry tool with finger on trigger.
Disconnect battery, engage lock-off, use stall release and jam latch to clear jams.
Check battery pack installation/charge, trigger lock-off.
Check battery, motor status, jammed fastener/mechanism.
Check pack insertion, charger connection, temperature.
